What is Hunter Pro C?

The Hunter Pro C Series is your cost-effective irrigation controller. And if you elect to have the new Solar Sync as a running mate, the PCC is designed for the sensor to be installed directly in the controller cabinet, for a compact, coordinated sprinkler system.

In respect to this, how do I manually start a hunter pro c sprinkler system?

Pro-C - One Touch Manual Start and Advance

1. With the dial in the RUN position, hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can select program B, or C by pressing the PRG program.
3. The station number will be flashing.
4. Press the button to scroll to the station you wish to begin with.

Also, how do you wire Hunter Pro C? How to Connect Hunter Pro-C Station Wires

1. Route valve wires between control valve location and controller.
2. At valves, attach a common wire to either solenoid wire of all valves.
3. Route valve wires through the conduit and attach conduit to one of the openings on the bottom of the cabinet.
4. Strip ½” (13 mm) of insulation from ends of all wires.

Also to know is, how do you winterize a hunter pro c sprinkler system?

To start the blow out, shut off the irrigation water supply and, with the compressor valve in the closed position, attach the air compressor hose to the fitting. Activate the station on the controller that is the zone or sprinklers highest in elevation and the furthest from the compressor.

What does no AC mean on a sprinkler system?

The "NO AC" display is a diagnostic message telling you that the controller has stopped receiving AC power. The controller is running on the power supplied by the backup battery. Check the power source by plugging a lamp or radio into the wall outlet to verify there is power at the outlet.

How do I reset my Hunter Pro C?

Watch Video

1. Press and hold the program button.
2. Press and release and the RESET button on the back of the front panel.
3. Wait until the display shows 12:00 am.
4. Release the button.

How do you change the time on a Hunter Pro C?

Pro-C - Setting the Current Date and Time

1. Turn the dial to the DATE/TIME position.
2. The current year will be flashing in the display. Use the and buttons to change the year.
3. The month will be flashing. Use the and buttons to change the month.
4. The day will be flashing.
5. The time will be displayed: Use the and buttons to select AM, PM, or 24 hr.

How do you test a hunter sprinkler system?

To initiate the test program:

1. Press and hold the PRG button. The station number will be flashing.
2. Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes.
3. After a 2 second pause, the test program will begin.

How do you manually run a sprinkler system?

Pro-C - Manually Run a Single Station

1. Turn the dial to the MANUAL position.
2. Station run time will flash in the display. Use the button to move to the desired station.
3. Turn the dial to the RUN position to run the station (only the designated station will water, then controller will return to automatic mode with no change in the previously set program).

Why does my sprinkler system keep running?

There are two reasons why your sprinklers would continue running: It's possible your valves have been opened manually. You'll need to locate your valve box(es) and turn the solenoid(s) clockwise until snug. The solenoid is located on the top of the valve and looks like a cylinder with two wires protruding out of it.

Why wont my sprinklers turn on?

The most common cause of individual sprinklers not coming on is blockage. The thin spray opening of a sprinkler head easily becomes clogged with dirt and debris. Inspect malfunctioning sprinkler heads while the water supply is off, and clear blockages with a thin, straight-edged tool such as a screwdriver.