How much does it cost to replace a water pump in a Toyota Camry?

The average cost for a Toyota Camry water pump replacement is between $389 and $521. Labor costs are estimated between $270 and $342 while parts are priced between $119 and $179. Estimate does not include taxes and fees.

Moreover, how expensive is it to replace a water pump?

According to CostHelper, water pump replacement averages $300 to $750, depending on the make and model and labor costs. The water pump itself may only cost $50 to $100, but labor can run between $200 and $450, depending on the difficulty level of reaching the pump.

Beside above, how much is a water pump for a 2009 Toyota Camry? Or you may just be struggling to keep it highway-approved. No matter the situation, Advance Auto Parts has the Water Pump product you desperately need. We currently carry 8 Water Pump products to choose from for your 2009 Toyota Camry, and our inventory prices range from as little as $34.41 up to $168.57.

Also know, what are the symptoms of a bad water pump?

Here are some common symptoms that hint towards having a bad water pump:

  • Coolant leak at the front-center of your car.
  • Water pump pulley is loose and making whining sounds.
  • Engine is overheating.
  • Steam coming from your radiator.

How long will a water pump last after it starts leaking?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak.

Can I drive with a bad water pump?

Water pumps don't "break" and start leaking; they have things called "weep holes", so that when the bearings are starting to wear down, it will slowly start to drip, that way you know its time to replace it. If that is all that is happening, you're fine to drive it for a week or so.

Does water pump make noise when going bad?

When the water pump bearings go out it will cause a squeaking, ticking or grinding noise while the engine is running. This is because the shaft bearings are trying to lock up within the pump housing. This bearing failure is due to the pressure being applied by the serpentine belt or the timing belt.

What happens when the water pump goes out?

Catastrophic failure of your water pump will cause either a complete or partial loss of coolant flow and rapid overheating. If this happens to your vehicle, it may be accompanied by engine noise or a broken engine belt, but will definitely result in your engine temperature gauge rising quickly.

How many hours does it take to replace a water pump?

Expect to pay $200-$450 total for labor, depending on the how difficult it is to reach the water pump, any additional parts that need to be removed and whether the car uses a timing belt or timing chain. The job takes about three and a half to four hours to complete.

How long does a water pump take to replace?

The total time spent should be 3 to 4 hours for in-depth replacements.

Should I change water pump with timing belt?

Generally, the idler pulleys, tensioner and water pump should always be replaced when the timing belt is replaced. In most cases, the timing belt drives the water pump, so it is the right time to replace the water pump. It is also recommended by the manufacturer.

Will water pump leak if engine is off?

If it looks like leaking from bottom hose then it is most likely the water pump leaking down the hose. If cannot tell then have system pressure tested to see where the leak is coming from. Do not drive it or you may overheat engine and do more damage. The heater will not work correctly if low on coolant.

Does water pump affect AC?

No, but it will overheat and cause significant damage to the engine. If your AC is running, you are diverting coolant from your engine. If you have the proper amount of coolant in your system, it should not be a problem. But if your coolant is low, running the AC will contribute to overheating your engine.

How do you know when your water pump needs to be replaced?

What Are The Signs My Water Pump Is Going Bad?
  1. Overheating. An obvious sign of a faulty water pump is that your engine is overheating.
  2. Bad Noises. You also might be able to hear the problem.
  3. Coolant Leak. Another sign it's time to replace your water pump is one you might see beneath your car.

How do you know if your Headgasket is blown?

How To Tell if a Head Gasket Is Blown:
  1. Coolant leaking externally from below the exhaust manifold.
  2. White smoke from the exhaust pipe.
  3. Bubbles in the radiator or coolant overflow tank.
  4. Overheating engine.
  5. White milky oil.
  6. Fouled spark plugs.
  7. Low cooling system integrity.

How far can you drive without a water pump?

300 meters would be acceptable with an 90 minute break before proceeding a further 300m. “How far can a car drive without a water pump?”

How do you test a water pump?

If you suspect the water pump isn't working, replace the radiator cap and, using a shop rag to prevent burning your hand, squeeze the upper radiator hose (the one going from the radiator to the engine). With a working water pump, you should feel the surge of coolant as you release the radiator hose.

How do you stop a water pump from leaking?

Water Pump Leak Repair: Water Pump Removal
  1. Flush cooling system if necessary.
  2. Drain coolant.
  3. Remove engine belts.
  4. Remove other components to gain access to water pump bolts.
  5. Remove the water pump.
  6. Replace gasket or o-ring and install new pump.

How do you know if your engine block is cracked?

4 Symptoms of a Cracked Engine Block
  1. Overheating. If the crack in the engine block is severe enough and in the "right spot" it will cause antifreeze to leak from the block.
  2. Engine Smoke. Blackish-gray or blue smoke coming out from under the hood is a strong indication that there is a crack in the block.
  3. Antifreeze and Oil Mixing.
  4. Poor Engine Performance.

How do you check a car thermostat?

Start your car's engine and allow it to idle. Look through the radiator filler neck to see if the coolant flows. At this time, it should not be flowing as your car has not reached the operating temperature to cause the thermostat to open. If you find the coolant is flowing, it means the thermostat valve is open.

Can a bad water pump cause car not to start?

A broken water pump is a serious problem, that can cause overheating and serious engine damage, but will rarely ever affect the vehicle's starting ability. A weak or bad battery may not provide enough cranking power to successfully turn over the engine, and may result in a no start no crank condition.

Where is the water pump on a Toyota Camry?

How does the water pump work? The water pump is driven by an accessory belt at the front of the engine, or by the timing belt or timing chain.

You Might Also Like