How to Winterize your Evaporative Cooler
- Turn Power Off. First, turn the power supply off on your unit.
- Turn Water Supply Valve Off. In order to keep the pads inside of the unit wet, the cooler needs a water supply valve to bring water into the unit.
- Drain the Swamp Cooler.
- Cover the Unit.
Keeping this in consideration, how much does it cost to winterize a swamp cooler?
Winterizing a swamp cooler will cost about $100 to $150, not including parts. This will save you maintenance during the following summer, extend the life of the unit, and will include: Draining the unit.
One may also ask, how do I winterize my AeroCool? Winterizing Tips
- Shut off water supply line and loosen water connection at the supply to drain any water left in the line.
- If you are a proud owner of the AeroCool Pro Series, turn off the disconnect switch that is provided with the Pro cooler to prevent any damage from power surges.
Secondly, how do you prevent calcium build up in a swamp cooler?
You should regularly clean out the interior of the unit to prevent deposits from forming. The best cleaner is a simple mix of white vinegar and water. You should clean the water pan reservoir at the bottom of the cooler at least once a month throughout the season to prevent minerals from building up inside.
Should I cover my swamp cooler in the winter?
Block the Vent The final step to winterizing your swamp cooler is to cover the vent where the cooler blows air into the house. This vent is a possible source of heat loss in the winter, so it is a good idea to close and seal it during the winter months. Your evaporative cooler is now ready for winter.
How often should you change swamp cooler pads?
Some common brands of cooling pads are the Aspen and Cellulose. If you have Aspen cooling pads, you should change them at the beginning of each season or sooner, depending on the mineral deposits built up on the pad. Cellulose, or CelDek, pads last longer and require changing every 3 to 5 years.When should I winterize my swamp cooler?
Every evaporative cooler has a water supply line. The supply line should be winterized before the start of the winter by an HVAC professional. That's because freezing conditions here in the Albuquerque and Santa Fe area can freeze any remaining water in the lines, causing them to burst.How do you maintain a swamp cooler?
Follow the tips below to learn how to properly maintain your swamp cooler in order to maximize its cooling efficiency.- Thoroughly clean the exterior of the unit.
- Regularly replace the cooling pads.
- Clean the water tank.
- Maintain proper water levels.
- Use water treatment tablets.
How do I turn off the water to my swamp cooler?
However, here are the basic steps:- Turn Power Off. First, turn the power supply off on your unit.
- Turn Water Supply Valve Off. In order to keep the pads inside of the unit wet, the cooler needs a water supply valve to bring water into the unit.
- Drain the Swamp Cooler.
- Cover the Unit.
How much does it cost to run a swamp cooler all day?
At a cost of $0.15 per Kwh (Kilowatts per Hour), the A/C systems costs $1.13 per hour to run where by the Evaporative cooler cost is only $0.26 per hour.How often should evaporative cooling be serviced?
The recommendations for how often evaporative cooling should be serviced depends on the brand and model. The general recommendations to ensure maximum efficiency may range from checks on an annual basis to having the cooling system checked every 2-3 years.How much is a swamp cooler motor?
Compare Similar Products| 2-Speed 1/2 HP Evaporative Cooler Motor | 1-Speed 3/4 HP Evaporative Cooler Motor | 2-Speed 1/2 HP Evaporative Cooler Motor Kit |
| $84.00 | $100.64 | $119.99 |
| (235) | (10) | (34) |
| Horsepower (hp) .5 hp | Horsepower (hp) .75 hp | Horsepower (hp) .5 hp |
| Details Above | View Details | View Details |
How do you service an evaporative cooler?
How to Service An Evaporative Air Conditioner- Remove filters & wash with a hose,
- If you have an old system, pull out the sump dump to release the water from the tank,
- If you have a new system there will be no water because the dump valve clears the tank automatically,
- Wipe out the inside of the unit where the water tank is,
