How do you scribe a stair skirt?

To scribe skirt board over installed risers and treads, start with a straight skirt board laid on top of the points of the treads with the bottom corner against the finish or sub-floor, and the top corner above and beyond the top tread nosing.

Subsequently, one may also ask, do you need a stair skirt?

You don't have to install skirt boards. Just like you don't have to install any molding in your house. However there is a difference here compared to your normal baseboards. you are usually moving with more force on stairs.

One may also ask, how wide should a stair skirt be? You must make sure to select a piece of material that is long enough to cover the total run of the staircase. The width should be at least 9-1/2-inches wide. A second consideration is the thickness of the skirt board. Thickness is a variable that is based on aesthetical purposes and not for structural stability.

Furthermore, what wood is used for stair skirts?

Place the 1/2-by-10-inch piece of hardwood from which you'll make the skirtboard diagonally along the wall, with the bottom of the hardwood touching the nose of each tread as it descends the steps. The piece of hardwood should be at least 12 inches longer than the length of the steps, if possible.

Does stair riser sit on top of tread?

The riser is installed first for the reason that you want a nice tight fit along the top of the riser to the tread above it. An experienced carpenter will install the risers and treads from the top of the stairs down so that they can always be fitting the next riser against the bottom of the previous tread.

How do you cut stair molding?

Set the scrap piece of stair trim molding on the flat stair landing, in the position it would be if it were installed. Slide the trim along the landing until it overlaps with the position that would be occupied by the adjoining piece of trim. Trace along the top of the trim on the wall with a sharp pencil.

How do you attach a stringer to stairs?

Rip the plywood 10 1/4" wide or to match your finish stair stringer board's width. Lay the template down on the stair treads, up against the wall on the angle it will be installed in, with the corner of the end of the board just resting on the lower floor. Fasten this board to the wall or have someone hold it steady.

Can you make your own stair treads?

When you must replace oak stair treads you have two options available to you. One option is to buy new replacement treads. The other option is to make your own. While this option involves a little more work than just buying a new one, it will save you some money and ensure that you get the tread that you want.

How thick should stair treads be?

As you may have noted from the sketches and text above, typically building codes for stairs specify minimum stair tread thickness (1" if supported by a riser at front, or 1 1/2" thick treads if the stairs are open-construction without risers), but they do not specify a maximum allowable tread thickness.

What saw to cut stair treads?

For starters, to cut a full 11-1/2" stair tread, a 12" sliding miter saw is best. This will allow you to make a full 12" cut in one pass. Using a 10" or smaller saw that doesn't slide means you'll have to make two cuts on each side of the tread and is very difficult to achieve a quality cut.

What is Skirtboard?

In architecture, a baseboard (also called skirting board, skirting, mopboard, floor molding, or base molding) is usually wooden or vinyl board covering the lowest part of an interior wall. Its purpose is to cover the joint between the wall surface and the floor.

What is risers on a stair?

A stair riser is the near-vertical element in a set of stairs, forming the space between one step and the next. It is sometimes slightly inclined from the vertical so that its top is closer than its base to the person climbing the stairs.