How do you Rethread a curtain cord?

Push one end of the drapery cord up into the pulley housing on the left side of the left pulley. There are two pulleys inside the housing, and the cord should be on the left side of both. Work the cord over the top of both pulleys toward the right, then pull the end out the right side of the pulley housing.

Subsequently, one may also ask, how do you replace a pull cord on a curtain?

Remove the old cord and cut a new cord the same length plus 8 inches. If your cord is missing, the length of cord you need is equal to twice the width of the curtain rod and twice the length of the draw cord, which is the long loop that hangs down the side of the drapes, plus 8 inches.

Beside above, what curtains for traverse rod? Traverse Curtains

• ChadMade Pinch Pleated Curtain 100W x 84L Inch Solid Thermal Insulated Blackout Patio Door Panel Drape for Traverse Rod and Track, Beige (1 Panel)
• Rod Desyne Rosen Traverse Rod, 86-120 inch, Pewter.
• HPD Half Price Drapes VPCH-VET160401-84 Signature Extra Wide Blackout Velvet Curtain (1 Panel), 100 X 84, Reflection Grey.

Regarding this, how do you restring a traverse curtain rod?

1. Remove the drapes from the rod and remove the rod from the window.
2. Lay the rod on a table with the window-side of the rod visible.
3. Remove the old cord.
4. Cut a piece of cord equal to twice the width of the curtain rod and twice the distance from the rod top to the floor, plus 6 inches.

How do you make a curtain pulley?

Install a single stationary pulley on the left end of the curtain rod. Ensure that the top of the cord path through the pulley is level with the center of the eye screws on the wooden rings. Install a double stationary pulley on the right end of the curtain rod. Shim the pulleys if necessary.

What are the different types of curtains?

Here are the seven most popular curtain styles:

• Pinch pleat (or tailored pleat) curtains.
• Box pleat curtains.
• Goblet pleat curtains.
• Pencil pleat curtains.
• Eyelet (grommet) curtains.
• Rod-pocket curtains.
• Tab-top curtains.

How does a traverse curtain rod work?

Traverse rods have clips or eyes that move along a track embedded in a slot in the rod. The eyes have a small opening for the curtain pins and they'll run evenly across the rod, with the number of eyes dependent on how long the rod is. A cord runs through the rod, too, and is attached to a master slide or pulley.

How does a curtain work?

Curtains are often hung on the inside of a building's windows to block the passage of light, for instance at night to aid sleeping, or to stop light from escaping outside the building (stopping people outside from being able to see inside, often for privacy reasons).

How do you record a curtain rail?

How to Thread Cord on Curtain Rails

1. Remove the curtains from the traverse rods so you can access the cording.
2. Measure the rod's length while it is still on the wall.
3. Remove the curtain rod from the wall and place it on a work surface with the pulleys facing upward.
4. Insert the end of the cording up and over the pulley on the left side of the curtain rail.