How do you program a Kwikset deadbolt lock?

Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 - 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once.

Considering this, what is the program button on Kwikset lock?

While the door is open, press the “Program” keypad button located on the interior side of the door. Enter a four to eight digit security code that you can easily remember on the outside electronic lock keypad. Press the “Lock” keypad button at the center of the SmartCode keypad.

Similarly, how do you reset a Kwikset 909 lock? Press and hold the "lock" button on the exterior keypad while installing the battery pack. Continue to hold down the "lock" button until the latch bolt starts moving on its own.

Also to know is, how do I reset my Kwikset lock?

A factory reset will delete all codes associated with the lock.

1. Make sure the door is open and unlocked.
2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
3. Press and release the program button. You will hear one short beep.

How do I program my Kwikset SmartCode?

1. Open the door.
2. Remove battery cover.
3. Press the program button once.
4. Enter new user code.
5. Press lock button.
6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do you reset a Kwikset Powerbolt 2?

How to restore default settings on my Powerbolt 2? Perform a factory reset

1. Make sure the door is open and unlocked.
2. Enter the default Mastercode (O-O-O-0).
3. Press the lock button.
4. Press 0.
5. Press the lock button.
6. Test the lock: With the door open and unlocked, Press the lock button.

How do you change the code on a Kwikset electronic deadbolt?

Press the PROGRAM button once, enter your new 4 - 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once. If your old code still remains in the unit, you will need to perform a hard reset of the unit.

How do you put a Kwikset lock in pairing mode?

To connect a Z-Wave Kwikset lock in the SmartThings Classic app

1. Tap My Home.
2. Under Things, tap Add a Thing at the bottom of your Things list.
3. The app will say Looking for devices…
4. While the Hub searches, Remove the battery cover. Press the “A” button once.