How do you change the drive belt on a Scotts s1742?

How to Replace a Belt on a Scotts S1742 Lawn Mower

1. Drive your Scotts S1742 mower onto level, stable ground and set the parking brake.
2. Disengage the PTO, or blade, lever to stop the blades from rotating.
3. Raise the adjustment lever for the mower deck to position the deck as high off the ground as possible.
4. Remove the cotter pins from the suspension rods.

Also question is, how do you adjust a deck on a Scotts riding mower?

Adjusting Mower Level (Side-to-Side)

1. Park tractor on a hard, level surface.
2. Stop engine and remove key.
3. CHECK: Tire pressures must be correct. ( See Checking.
4. Adjust cutting height to middle position. A.
5. Turn left blade parallel to tractor axle. Hold drive belt and.
6. Measure from each outside blade tip (A) to the level.

Also Know, how do you remove a Scotts mower deck? How to Remove the Mower Deck on a Scotts S2046 Lawn Tractor

1. Park the mower on a flat surface and stop the engine.
2. Slide two, 2-by-4 wood blocks under each side of the mower deck.
3. Locate the belt guide next to the pulley behind the left front wheel on the mower deck.
4. Locate and remove the spring locking pin and washer that hold the tension rod onto the blade drive arm.

Considering this, how do you change the drive belt on a John Deere Sabre?

No matter which Sabre tractor you own, the drive belt removal process is basically the same.

1. Stop the engine.
2. Disconnect the spark plug wire from the engine to prevent it from starting.
3. Adjust the lift lever to the "Transport" position.
4. Adjust the cutting height knob to 25 mm, or 1 inch.

How does a mower deck work?

Instead of cutting grass like scissors cut paper as a reel mower does, the rotary mower spins a horizontal blade around fast enough to cut the grass as it hits it. The blade sits within a casing called a deck, which keeps the grass and other objects from flying in all directions when struck.

Who made Scotts riding mowers?

John Deere

Should a mower deck be level?

Deck pitch is very important to be able to get the most amount of productivity out of your mower. A deck should be level from side to side and the front should be slightly lower than the back.

How do I lower my John Deere mower deck?

Release Transport Lock

1. Raise mower deck using deck lift pedal.
2. Rotate transport lock knob clockwise. Knob will release to off position.
3. Release pedal to lower deck to previous height of cut setting.

How do you start a Scotts riding mower?

Start the engine of the Scotts S1742 riding lawnmower engine, idle it for a few minutes and set the engine throttle to the "Fast" position. Press and hold the brake pedal down with your left foot to release the park brake.

Why does my John Deere mower belt keep breaking?

the most common cause of the deck belt breaking would be a idler or mandrel pulley not lined up properly or the bearings going out and making the pulley wobble or the belt is getting rubbed somewhere. check the pullies on the deck to make sure they turn freely and are not loose and wobbling around.

How do you change a belt on a John Deere riding mower?

Pull the spring pin and washer off the mower deck bracket and remove the front draft rod. Work the belt from around the engine pulley and slide the cutting deck from underneath the John Deere mower. Loosen and remove the screws that hold the belt shields in place with a screwdriver.