The Daily Insight

Home / updates

How do I set up my Ismart camera?

David Osborn |
Connecting to your iSmart IP camera* The settings for iSmart cameras are built right into our open source surveillance software iSpy and our Windows Service based platform, Agent - click "Add" then "IP camera with wizard" to automatically setup your iSmart cameras. Start typing in the "Make" box to find your camera.

Furthermore, how do I reset my Ismart camera?

If you're prompted to reset the camera,

  1. On the back of the camera, you'll find a small hole labeled "Reset" on the right.
  2. Insert a small paper clip or pin into the hole and you should feel a small click.
  3. Press down and hold the button in place for 30 seconds.

Likewise, how do I update Ismartalarm firmware? 1) Navigate to the Control page. The app will have a pop up window to update CubeOne's firmware. 2) Go to more->Device Setting->CubeOne and tap on the Update button at the upper right corner. To update iCamera KEEP's firmware, go to iCamera KEEP's live view page.

In respect to this, how do I change my WiFi on Ismartalarm?

How to connect the camera to different Wi-Fi network

  1. Enter your camera's live video page.
  2. Tap Settings.
  3. Tap Reset Wi-Fi.
  4. Follow the remaining instructions in the app to finish the setup.

How do I connect my iCamera 1000?

  1. Connect blackcable to camera (the large network cable)
  2. Connect the white (Y-split) to the black cable.
  3. Plug the Y-split network cable into the ADT hub.
  4. Plug in the power.
  5. Wait for TWO green lights on the front.
  6. Log into ADT and setup the camera (System > Manage Devices > Cameras > iCamera-1000)

How do you reset a cube?

Here's how to do it:
  1. Plug in the new CubeOne and wait for the solid red LED to change to breathing white.
  2. Launch the iSmartAlarm App.
  3. Go to Devices.
  4. Tap on your old CubeOne.
  5. Tap Settings.
  6. Tap Restore System.
  7. Follow the remaining instructions in the app.

How do I reset my Ismart alarm cube?

How to restore the CubeOne to factory settings
  1. The Superuser must login to their account in the iSmartAlarm App.
  2. Go to Devices > select your CubeOne.
  3. Tap Settings > Remove Device.

Why is my iSmartAlarm offline?

If your system goes offline due to a bad cable, and you delete the system, you will have to remove the batteries for all sensors, re-install the sensors, and if your issue was related to the CubeOne being offline, you'll end up with no iSmartAlarm system, and push yourself even further away from resolving the issue.

You Might Also Like